Apogee TS-100 Manuale del Proprietario

APOGEEINSTRUMENTS,INC.721WEST1800NORTH,LOGAN,UTAH84321,USATEL:(435)792‐4700FAX:(435)787‐8268WEB:APOGEEINSTRUMENTS.COMCopyrigh

10The underside of the hat has eight flat surfaces where one or more included cable tie mounts may affix. Using the cable tie mounts is optional, b

11OPERATION AND MEASUREMENT Connect the sensor to a measurement device (meter, datalogger, controller) capable of inputting 2.5 V DC, and measurin

12An excitation voltage of 2.5 V DC is recommended to minimize self-heating and current drain, while still maintaining adequate measurement sensiti

13Measurement of PRT resistance is very similar to measurement of thermistor resistance, where a half-bridge measurement is used. An excitation vol

14Fan Operation: Under some environmental conditions (e.g., high wind speed, low solar radiation), accurate measurements can be made without runni

15MAINTENANCE AND RECALIBRATION At full duty, the fan is designed to last 50,000 hours (5.7 years). Ultimately, this depends on operating conditio

16TROUBLESHOOTING AND CUSTOMER SUPPORT Independent Verification of Functionality: Apogee ST-110 temperature sensors yield a resistance proportiona

17compatible measurement device should have resolution of at least 0.008 mV, in order to produce temperature resolution of less than 0.1 C across t

18RETURN AND WARRANTY POLICY RETURN POLICY Apogee Instruments will accept returns within 30 days of purchase as long as the product is in new co

193. Please write the RMA number on the outside of the shipping container. 4. Return the item with freight pre-paid and fully insured to our facto

2TABLE OF CONTENTS DECLARATIONOFCONFORMITY……………………………..……………………. 3INTRODUCTION…………………………………………………………………………….. 4SENSOROPTIONS...

3DECLARATION OF CONFORMITY CE and ROHS Certificate of Compliance We Apogee Instruments, Inc. 721 W 1800 N Logan, Utah 84321 USA Declare under ou

4INTRODUCTION Properties of materials and nearly all biological, chemical, and physical processes are temperature dependent. Temperature is also a

5SENSOR OPTIONS TS-100 aspirated radiation shields accommodate multiple air temperature and humidity sensors using sensor port adapters. The follo

6SPECIFICATIONS TS-100 Radiation-induced Temperature Increase (RITI): There is no reference standard for the elimination of radiation effects on

7digit in the IP rating indicates protection against particle entry. A 5 indicates minimal dust entry with no interference with fan operation. The

8ST-300 (Platinum Resistance Thermometer) Measurement Range: -50 to 70 C Measurement Uncertainty: 0.2 C (from -40 to 60 C) Measure

9DEPLOYMENT AND INSTALLATION TS-100 aspirated radiation shields come partially pre-assembled and have few parts, facilitating easy transport, depl